Skip to content

ABA CPT codes, 97151 through 97158

Applied behavior analysis is billed under a family of eight Category I CPT codes, 97151 through 97158, in use since January 1, 2019, plus two Category III codes for severe destructive behavior. The codes describe who delivered a service and in what format - assessment or treatment, one learner or a group, technician or qualified professional, learner or caregiver - so picking the right one starts with knowing who was in the room. This is a plain-language reference; the payer's policy always has the final word.

  • Reviewed November 2026
  • 7 min read

How the ABA code set is organized

The adaptive behavior codes replaced the earlier Category III codes on January 1, 2019. They distinguish two kinds of provider. A qualified health care professional (QHP) is the behavior analyst - typically a BCBA or a licensed behavior analyst, or another licensed professional whose scope covers behavior analysis, depending on state law and payer policy. A technician, commonly a Registered Behavior Technician (RBT), delivers services under a QHP's direction.

Every code is timed in 15-minute units, and only face-to-face time with the learner or caregivers is reported - with one exception. The assessment code 97151 also includes the QHP's non-face-to-face work of analyzing past data, scoring and interpreting the assessment, and writing the report or treatment plan. Other indirect work, such as preparing materials or writing session notes, has no separate CPT code; it is paid as part of the face-to-face rate unless a payer contract includes another code for it.

The eight codes at a glance

The table summarizes what each code covers. The official descriptors are published by the American Medical Association in the CPT code book; the ABA Coding Coalition publishes supplemental guidance on applying them.

The Category I adaptive behavior CPT codes, paraphrased from the AMA descriptors and ABA Coding Coalition guidance. All are reported in 15-minute units; payer policy governs coverage, credentials, and limits.
CodeWhat it coversDelivered byWho is present
97151Behavior identification assessment: the initial assessment and reassessments, including scoring and writing the report or treatment plan.QHPThe learner and/or caregivers, for the face-to-face part
97152Supporting assessment: additional assessment the QHP directs a technician to carry out, such as structured observation of a behavior.One technician, under QHP directionThe learner
97153Adaptive behavior treatment by protocol: direct one-to-one treatment that follows the written protocol.Technician, under QHP directionOne learner
97154Group adaptive behavior treatment by protocol.Technician, under QHP directionTwo to eight learners
97155Adaptive behavior treatment with protocol modification: the QHP treats the learner directly, or directs a technician with the learner present.QHPOne learner, often with a technician
97156Family adaptive behavior treatment guidance: training caregivers to carry out the treatment.QHPCaregivers, with or without the learner
97157Multiple-family group adaptive behavior treatment guidance.QHPCaregivers from several families, without the learners
97158Group adaptive behavior treatment with protocol modification: a group session led by the QHP.QHPTwo to eight learners

Units and the 8-minute threshold

Each unit is 15 minutes. Under the CPT time rule, a unit can be reported once more than half of it has passed, so 8 to 22 minutes is one unit and under 8 minutes is not reportable. In practice an hour of 97153 is four units and a two-hour session is eight. Some payers apply their own rounding rules or require exact start and end times, so check the contract before building units into a schedule.

Only the time that matches the code counts. For 97153, that is face-to-face treatment time with the learner; setup, data entry after the learner leaves, and note writing are not added to the units. For group codes, each learner's claim reports the time that learner spent in the group.

Who bills which code

The technician codes - 97152, 97153, and 97154 - describe services a technician delivers. The QHP codes - 97151, 97155, 97156, 97157, and 97158 - describe services the behavior analyst delivers. An RBT's direct one-to-one session is 97153; an RBT does not bill 97155, which is a QHP service by definition. When a QHP steps in to run a session exactly as a technician would, without changing the protocol, the guidance is to report 97153 with whatever modifier the payer uses to identify the higher-level provider.

Payers add rules of their own. Some require modifiers that identify the rendering clinician's education or credential level - HM, HN, HO, and HP are common - some limit which credentials may render which codes, and some cap hours per day or week. Assistant behavior analysts (BCaBAs) practice under a BCBA's supervision, and which codes they may render is set by state law and payer policy.

Supervising technicians without the learner present is not billable under CPT; it is indirect work bundled into the direct-service rates, though some payers allow a separate HCPCS code for it. Supervision delivered with the learner present, directing the technician, is billed as 97155. The RBT supervision requirements guide covers how much of that supervision the BACB requires.

Billing 97155 and 97153 at the same time

According to ABA Coding Coalition guidance, 97155 and 97153 may be reported for the same time period when the requirements of both codes are met: a technician delivers treatment under 97153 while the QHP, present with the learner and technician, directs the technician or modifies the protocol under 97155. They must be two different people; a single QHP cannot report both codes for the same time. The same applies to 97155 with the group code 97154.

Some combinations are not allowed. 97154 and 97158 cannot be reported together, because 97158 is for groups the QHP leads. 97155 cannot be used for treatment planning while a technician works with the learner elsewhere, because the code requires face-to-face time with the learner. And not every payer reimburses concurrent 97153 and 97155 even where CPT permits it; some, including some state Medicaid programs, have limited or ended it, so confirm the payer's policy first.

The Category III codes: 0362T and 0373T

Two Category III codes cover assessment and treatment of severe destructive behavior, such as self-injury, aggression, or other behavior with high-risk medical consequences. 0362T is a supporting assessment, typically a functional analysis; 0373T is treatment with protocol modification. Both require the QHP to be on site and immediately available, the assistance of two or more technicians, and an environment customized to the learner's behavior.

Units for these codes count one technician's face-to-face time, not the total across technicians: a three-hour session staffed by three technicians is reported as 12 units. 0373T cannot be billed concurrently with 97155, because the QHP's direction is part of the code. Category III codes are covered less consistently than Category I codes, so preauthorization is usually advisable.

Documentation that supports the code

A session note should let a reviewer confirm the code without asking. That means the code itself, the rendering clinician and their credential, start and end times that match the units billed, who was present, and what was done - treatment by protocol, a protocol change, or caregiver training - with the session's data attached. A 97155 note should say what was modified or directed; a 97156 note should name the caregiver and the skills practiced.

Units also have to fit the authorization. Tracking authorized units against delivered units by code, and flagging an authorization before it runs out, prevents the most avoidable denials. For what to look for in software that does this, see how to choose ABA data collection software.

How Cadence handles ABA codes

Every session in Cadence is scheduled and documented under a code from the 97151-97158 family, and every note carries its session's code. Caregiver training maps to the family-guidance codes it is billed under, 97156 and 97157.

On the Practice plan, Cadence checks each session's code against the role of the clinician who delivered it - an RBT session booked as 97155 is flagged - tracks authorized units against delivered units, validates CPT mapping, modifiers, and payer-specific rules before a claim draft leaves the clinic, and exports claim drafts as 837P files for a biller to upload to a clearinghouse. Cadence is not a full revenue-cycle system: claim submission, remittance posting, and denial work stay with your biller.

FAQ

Common questions

What are the CPT codes for ABA therapy?
ABA is billed under eight Category I CPT codes, 97151 through 97158: 97151 and 97152 for assessment, 97153 and 97154 for technician-delivered treatment, 97155 and 97158 for treatment delivered by the behavior analyst, and 97156 and 97157 for caregiver guidance. Two Category III codes, 0362T and 0373T, cover assessment and treatment of severe destructive behavior.
What is CPT code 97153?
97153 is adaptive behavior treatment by protocol: direct one-to-one treatment delivered by a technician, commonly an RBT, under the direction of a qualified health care professional such as a BCBA. It is reported in 15-minute units of face-to-face time with the learner.
What is the difference between 97153 and 97155?
97153 is one-to-one treatment delivered by a technician following the written protocol. 97155 is treatment delivered by the qualified health care professional, such as a BCBA, which involves modifying the protocol and may include directing a technician while the learner is present.
Can 97153 and 97155 be billed at the same time?
Under CPT and ABA Coding Coalition guidance, yes, when both codes' requirements are met: a technician delivers 97153 while a different person, the qualified health care professional, delivers 97155 with the learner present. One person cannot report both codes for the same time, and some payers do not reimburse concurrent billing, so check the payer's policy.
How many minutes is one unit of an ABA CPT code?
Each unit is 15 minutes. Under the CPT time rule, a unit can be reported once more than half of it has passed, so 8 to 22 minutes counts as one unit and under 8 minutes is not reportable. Some payers apply their own rounding rules.
Can an RBT bill 97155?
No. 97155 describes treatment delivered by a qualified health care professional, such as a BCBA, so an RBT's direct one-to-one treatment is billed as 97153. When a BCBA directs an RBT during a session with the learner present, the BCBA's time may be billed as 97155 alongside the RBT's 97153, subject to payer policy.
Keep reading

Data collection that holds up

Cadence captures every ABA measurement system natively, measures interobserver agreement in-product, and drafts the billable note from the data you just committed - for a clinician to review and sign.